Every cable in the building should land in one place — a properly sized rack where your ISP feed, switches, router, and patch panels are mounted, dressed, and labelled so anyone can look at it and understand the network in seconds.
We build the rack out, not just drop equipment into it: patch panel placement, cable management, power, and airflow are all planned before the first screw goes in.
A rack build is a small design project, not just mounting hardware.
All prices CAD, labour + OpticPulse-supplied materials. Build an exact estimate for your project on the pricing page.
You supply the rack & patch panel; we mount, terminate, dress & label.
Add and label an additional port to an existing patch panel.
Audit an existing rack or closet and recommend a clean-up plan.
A few questions specific to this service.
It depends on your equipment count and growth plans. A single-family home might need a 6U wall-mount cabinet; a multi-unit building's main telecom room could call for a full 4-post 42U rack. We'll size it during the site visit.
Typically you supply the rack, switches, router and any active hardware; we supply the patch panels, cable, and connectors, and handle the mounting, termination, dressing and labelling.
Yes — a lot of our rack work is re-dressing and re-labelling an existing closet that's grown messy over time, without a full rebuild.
Yes — we'll size and mount a UPS so your network and NVR ride through short power interruptions instead of dropping immediately.
Send your blueprint, drop count, or a few photos. We'll confirm a site visit and a clear quote in CAD — we supply the cabling, you supply the devices, we install.