Smart Home Pre-wire

Wire it before the drywall goes up

Smart home pre-wiring means running the low-voltage pathways for automation, audio, lighting control, and sensors while the walls are still open — so nothing gets cut, patched, or repainted to add it in later.

You don't need to pick every device today. Pre-wire the pathway now, and whatever you (or the next owner) decides to add later — an extra camera, an access point, a Control4 or Lutron retrofit — goes in through cable that's already there.

Request a Quote See Pricing
New home rough framing showing labelled Cat6A and low-voltage pre-wire runs
Why It's Worth Doing Now

Open walls are the cheapest time you'll ever have

Once drywall closes, every future run costs more — in dollars and in patch-and-paint hassle.

  • No drywall cuts, no patch-and-paint — every pathway goes in while the framing is open
  • Extra low-voltage runs left capped at attic/basement for future cameras or access points
  • Audio, lighting & sensor pathways staged for Crestron, Control4, or Lutron — install the control system whenever you're ready
  • A labelled room map handed over at the end, so anyone who touches the house later knows exactly what's behind each wall
  • A future network upgrade — faster switch, mesh Wi-Fi, an NVR — plugs into existing cable instead of triggering a renovation
  • Adds resale value: a documented, wired home is a selling point most buyers notice
Cat6A pre-wiring and certified testing in a single-family home
Pricing

What it typically costs

All prices CAD, labour + OpticPulse-supplied materials. Build an exact estimate for your project on the pricing page.

Ethernet Pre-Wire

from $195 CAD / drop

Cat6A solid-copper drop, cable + termination + certified test, single-family rate.

Extra Capped Run

$149 CAD / run

A capped-off future-use run left at a panel or ceiling point, ready for the next device.

PoE Camera Pre-Wire

from $250 CAD / camera

Solid copper run to a future camera location, capped and labelled for later install.

Full Pricing & Instant Estimate
Common Questions

Smart home pre-wire questions

A few questions specific to this service.

Yes, and it's the most common scenario. We run generic low-voltage pathways to the right locations now (keypads, speakers, sensors, panel) and cap them off — you decide on Control4, Lutron, Crestron, or something else whenever you're ready.

A couple of capped runs per key area — over the garage door, at soffit corners for future cameras, near a media wall — is cheap now against a much bigger cost once drywall is closed. We'll walk your plan and suggest specific spots.

Every run is labelled and capped or terminated to a blank wall plate, so it's safe, tidy, and easy to find on a room map when you're ready to activate it.

Smart home pre-wire uses the same structured cabling discipline — it's just aimed at automation, audio, lighting and sensor points rather than a work-area data jack. See our structured cabling page for the underlying system.

See all frequently asked questions →

OpticPulse technician arriving on site with a cable coil and tool bag

Booking smart home pre-wires across Niagara.

Send your blueprint, drop count, or a few photos. We'll confirm a site visit and a clear quote in CAD — we supply the cabling, you supply the devices, we install.

Request a Quote Call or Text (289) 932-1603